The TORNADO has newly developed rotational technology inside the funnel to provide faster, more powerful cleaning. Professional detailers will love the speed and effectiveness of the TORNADO. The new design reduces wear and ensures a longer life and superior performance. The TORNADO is less noisy, too. The designers increased power but reduced air consumption and noise. Plus, the TORNADO is equipped with sealed ball bearings inside the rotation set. Wear is minimized because the rotation set no longer comes into contact with the cone. This improvement makes the TORNADO better suited for long term, frequent use, as in a professional detailing capacity.
The TORNADO can be used for all the same applications as the TORNADO Classic, but the is more effective on persistent spots and heavily soiled areas. The cone-shaped nozzle and oscillating tip create a tornado cleaning action that cleans hard and soft surfaces like nothing you’ve seen before. Dirt and grime are immediately released from fabrics, carpet, and solid surfaces.
The TORNADO releases a fine mist of cleaning solution that does not over saturate surfaces. You’ll quickly see the dirt and grime release from the surface. Wipe with a microfiber towel. Then turn the dial to shut off the water and use the compressed air to dry the cleaned area. It’s that simple. Use the TORNADOR on the dashboard, door panels, steering wheel, fabric upholstery, carpet, floor mats, and between seats. It cleans in tough-to-reach places between seats and in seams. On the exterior, use the TORNADO to clean fabric convertible tops, body seams, detailing of wheels, and emblems. There’s no need to scrub. The TORNADO does the hard work for you!
The TORNADO has an air regulator to allow you to change the working pressure directly on the tool. What this means is that you can adjust more pressure and cleaning fluid.
For this device you require an air compressor capable of producing at least 78psi of constant pressure; and no more than 110psi to avoid unnecessary wear.
Cleaning Fabric
1. Remove large debris and vacuum area to be cleaned.
2. Turn liquid air valve to upright position to deliver cleaning solution.
3. Hold cleaning nozzle 1 to 3 inches from area to be cleaned. Fully depress trigger. Begin with overlapping motion over area to be cleaned.
4. Next turn valve to down position using just air and dry the area.
Cleaning Dashboard and Hard Surfaces.
1. Recommended air pressure set at 78 psi
2. Turn liquid valve to straight up vertical position. Using a overlapping motion, spray area to be cleaned.
3. Allow cleaning liquid to remain on surface for 10 -15 seconds.
4. Follow with air only by turning valve to the horizontal down position. Begin drying with overlapping motion followed with a soft dry towel.
Maintenance (Important)
• Avoid dropping the gun on the floor
• Disconnect when not being used.
• Turn liquid valve to the horizontal position after use to avoid dripping from tip.
• Tighten the jar while holding the lid to avoid loosening or stripping gun assembly.
• When cleaning with the TORNADO use a microfiber towel to wipe any remaining debris or solution that needs to be wiped away.
• Keep the cone of the gun clean by removing the cone and rinsing frequently.
